SG350-28P 28-Port Gigabit PoE Managed Switch

[eempian]

i have this switch and i have ubiquiti Access point ( unify ac lite ) see attached photo

this AP wirks using POe ports. i cant power any AP. i read that class and limitaions found and i know my access works on 6.5 wt but i do no know how to change to class 2- or let switch power my AP

[AlKor]

Check the cable. Possible it is damaged.

Switch autodetect class. Class 0 is enough for work.

[Sujoy Paria]

Hi,

By default PoE ‘Power Mode’ is Class Limit in SG350 Switch. You may disable the PoE class error detection on the switch once and check. With this setting, if a class error is detected on an interface, it will be ignored and PD will be classified as class 0.

To disable PoE class error detection, use the power inline class-error-detection Global Configuration mode command. To return to default setting, use the no form of this command.

Syntax

power inline class-error-detection [enable|disable]

no power inline class-error-detection

Example:

switchxxxxxx(config)# power inline class-error-detection disable

Note: Please make sure the SG350 switch firmware is latest (2.5.0.83).

https://software.cisco.com/download/home/286288281/type/282463181/release/2.5.0.83?i=!pp