I configured 3 VLAN on a SG350-28P :
VLAN 1 (192.168.1.0 /24)
VLAN 100 +
[NAT Router] ---------------------- [Switch SG350]
VLAN 100 : 10.0.0.1 /24 10.0.0.2 /24 +
VLAN 10 (192.168.10.0 /24)
From VLAN 100 : I can access Internet, VLAN 1 and VLAN 10
From VLAN 10, I can access VLAN 1, VLAN 100 and ping 10.0.0.1
From VLAN 1, I can access VLAN 10, VLAN 100 and ping 10.0.0.1
But... from VLAN 1 and 10, I cannot access the Internet.
The SG350 itself can access the Internet, but from Interface 10.0.0.2 only.
All requests are correctly routed to the NAT router 10.0.0.1 and then... nothing.
Even from networks behind the router 10.0.0.1 (I have an intermediate 10.0.10.0 network before the Internet), I can access VLAN 1 and VLAN 10.
The request are routed to the gtw 10.0.0.1 but no further.
Do you have any idea to solve this issue ?
Thanks in advance for your help.
How is NAT configured on the router? Do you have an ACL or route-map confgured to determine which 'inside' subnets will be translated.
Can you provide us with the NAT statements from the router?
Thanks for the answer.
There is Static routing defined in the NAT router :
- Destination 192.168.10.0 - Gateway 10.0.10.2 - Interface LAN
- Destination 192.168.1.0 - Gateway 10.0.10.2 - Interface LAN
And from behind the NAT, I can access VLAN 1 and VLAN 10 (even 2 hops behind).
You misunderstand. The NAT process running on the router will typically be configured to translate traffic from a single 'inside' subnet and translate it using dynamic NAT to the 'outside' interface. On anything but the most basic router this NAT process can be configured, for example to specify a list of 'inside' subnets which can be translated to the outside interface.
You are probaly right.
This problem occured in my config environment, using a very basic router.
The switch will be deployed in the customer environment on thursday, connected to a true router.
I hope this will solve the issue.
We have essentially the same architecture (4 VLAN). It seems our prosumer router is not up the job. What feature in the router will get the job done? We have no need for PTP or VPNs. Just a single public IP on the WAN side currently. Will a RV130 get the job done?
Looking at the datasheet, the RV130 supports up to 5 VLANs, so it would support your requirements.
I think you have no route to internet
For fix this enter commands in SG350 CLI:
#conf t #default-router 10.0.0.1 #ip route 0.0.0.0 /0 10.0.0.1 metric 1 #do write #exit
If you already do route to 0.0.0.0 then show result from command:
#show ip route