cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
699
Views
0
Helpful
1
Replies

sg350 vlan mapping full configuration

Shtou
Level 1
Level 1

Hi everyone, I am trying to create a vlan mapping tunnel on a cisco sg350 switch, and I cant seem to figure out the full configuration.

From the documentation about the configuration,

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350-series-managed-switches/smb5822-configure-vlan-mapping-on-a-switch-through-the-cli.html?dtid=osscdc000283 

I understood the following:

vlan -mapping is done when packet enters interface, so vlan-mapping must be done on UNI interface, facing local network, and which must  be in trunk mode, and have the S-VLAN as an allowed VLAN, but I could not find any mention about the uplink interface configuration, I must match C-VLANS with 1 S-VLAN, I initially tried to do vlan-mapping on uplink but no succes so far.

1 Reply 1

Shtou
Level 1
Level 1
is the switchport mode vlan-mapping to be used on any interface? uplink/downlink or only plain trunk mode?
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X