Hi everyone, I am trying to create a vlan mapping tunnel on a cisco sg350 switch, and I cant seem to figure out the full configuration.
From the documentation about the configuration,
https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-350-series-managed-switches/smb5822-configure-vlan-mapping-on-a-switch-through-the-cli.html?dtid=osscdc000283
I understood the following:
vlan -mapping is done when packet enters interface, so vlan-mapping must be done on UNI interface, facing local network, and which must be in trunk mode, and have the S-VLAN as an allowed VLAN, but I could not find any mention about the uplink interface configuration, I must match C-VLANS with 1 S-VLAN, I initially tried to do vlan-mapping on uplink but no succes so far.
