sg500 slow snmp response

[Chris Chupela]

I've seen some previous mentions of this, but no resolution. I've got a SG500 52 port switch, on which SNMP is painfully slow. An snmpwalk running against the switch, might run as long as 45 minutes, returning small portions of the oid tree at a time.  This is impacting my ability to monitor the switch. Is there any way to get a faster response out of SNMP?

Thanks

[jddiez]

Hi there:

I've the same issue with all my SG500x. I tried to do a new View with just the oids i needed to check GE ports but problem is still there. I went to older versions for these SG500 and nothing. It is a biggest problem I found in these devices because it is no possible monitoring them.

Hope this problem has a solution.

Kind Regards.