SG500x-24 Ports and stacking

[HubaXUser1]

Hello,

we have one problem. We have two SG500X-24 Switches and we want to connect 4 x 10GBit/s and use also the stacking feature(with the other two ports)

But when we configure the switch with one of the two stacking modi in the webinterface, Port 3 and 4 aren't activated anymore? Is that a firmware limitation, or it isnt possible to use stacking and 4 port 10Gbit connection.

thank you and best regards,

Tarik

[christopher.tatton · Accepted solution]

The two ports are shared.  It's either one or the other.  You should be able to stack over the 10GbE links between the units however.