cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

CISCO SWITCHES FOR SMALL and MEDIUM BUSINESS

Introducing the next generation of Cisco Small and Medium Business Switches. Cisco is refreshing its SMB Switch portfolio. Click here  to learn more.


240
Views
0
Helpful
5
Replies
Beginner

SGE 2010 Changing Password Complexity

Hello,

 

Looking to change the password complexity of a Cisco SGE 2010 through CLI. Does anyone know the proper command set to do this?

5 REPLIES 5
Rising star

Re: SGE 2010 Changing Password Complexity

Beginner

Re: SGE 2010 Changing Password Complexity

I would need to make the changes in the cli, not the wub gui

Beginner

Re: SGE 2010 Changing Password Complexity

I would need to make the changes in the cli, not the wub gui
Rising star

Re: SGE 2010 Changing Password Complexity

OK.

I hope that this guide, can help you:https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb5563-configure-password-settings-on-a-switch-through-the-command.html#complex

sw(config)#: password complexity enable
sw(config)#: passwords complexity [min-length number] [min-classes number] [not-current] [no-repeat number] [not-username] [not manufacturer-name]

The options are:

min-length number — Sets the minimal length of the password. The range is from 0 to 64 characters. The default value is 8.
min-classes number — Sets the minimal character classes such as uppercase letters, lowercase letters, numbers, and special characters available on a standard keyboard. The range is from 0 to 4 classes. The default value is 3.
not-current — Specifies that the new password cannot be the same as the current password.
no-repeat number — Specifies the maximum number of characters in the new password that can be repeated consecutively. Zero specifies that there is no limit on repeated characters. The range is from 0 to 16 characters. The default value is 3.
not-username — Specifies that the password cannot repeat or reverse the user name or any variant reached by changing the case of the characters.
not-manufacturer-name — Specifies that the password cannot repeat or reverse the name of the manufacturer or any variant reached by changing the case of the characters.
Note: These commands do not wipe out the other settings. Configuring the passwords complexity settings only work as a toggle.
Jaderson Pessoa
*** Rate All Helpful Responses ***
Beginner

Re: SGE 2010 Changing Password Complexity

There's no command that begins with "passwords". Just gives:

SWITCH(config)# password complexity enable
% Unrecognized command