cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1082
Views
0
Helpful
0
Replies

SLM2008 dropping packaged

kompis_83
Level 1
Level 1

Hello,

after writing this post at the forum: http://homecommunity.cisco.com/t5/Wired-Adapters/SLM2008-dropping-packaged/td-p/497730
But "iamgiantherockstar" Told me to turn to this support forum.

I have recently looket at the following thread: http://homecommunity.cisco.com/t5/Switches/Linksys-SRW2008-Load-balance-setup/td-p/217487

I have also recently posted this on the QNAP forum: http://forum.qnap.com/viewtopic.php?f=50&t=56416

I don't know where the problem is, but perhaps someone here could give it a look and some tips. I am running the 802.3ad protocol and its LACP setup in the SLM2008 switch. You can see the images here: http://www.dropmocks.com/mBg-X8

The MTU is set to be 9000 on both servers and the SLM2008 Jumbo Frame enabled.

Sender-Server(ts-859)

Server1-SenderGraph2.png

Reciever-Server(ts-639)

Server2RecieverGraph2.png

Switch Config (SLM2008)

SWPortSettings.png

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X