Sorry this may be posted in the wrong thread though "Switches" appears in the archive section which I don't know why.
have a SRW2016 switch that I've been using for a year, recently I
changed my password to somehting else which contained special
charachters, the passwords looked like htis:
Another password was alpha numeric.
Each time I try login now I get the error message:
Access was denied due to one of the following reasons: 1) There are too many users logged in 2) The specified user name and/or password is incorrect.
I know for a fact no one else is logged in as it's on a 10.10.x.x IP range. Via telnet I get the same error.
I have a backed up copy of the config, so if I could somehow read this then perhaps I could tell what the issue is :/
If possible just give a try for password recover procedure for this switch,following are the steps to password recover applicable to Linksys switches :-
Physical access of the switch is required, in order to connect the serial cable.
This procedure applies to Linksys models SRW2016, SRW2024, SRW2048, SRW224G4, SRW248G4, and possibly other switches.
1.) Connect the Linksys serial cable that came with the switch between the switch serial port and a nearby computer serial port. For Windows, use Hyper Terminal or VanDyke CRT/SecureCRT. For Linux, use minicom. For other unix types, try cu/tip.
2.) The switch default serial port configuration is set to 38400 baud, 8 data bits, no parity, 1 stop bit, no flow control.
3.) Confirm that you have a valid serial connection by pressing enter a few times. You should be prompted with a login screen.
4.) If you have successfully established serial communication with the switch, reboot the switch by disconnecting and then reconnecting it's power cable.
5.) The switch will begin it's POST procedure as displayed in the serial terminal emulator. Be ready at the keyboard to press the Esc key.
6.) Watch for the following line to appear during the boot sequence. When you see it, immediately press the Esc key;
"Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom."
IMPORTANT: Do not hold down the Esc or Enter/Return key during the boot sequence. Only press the Esc key when prompted.
7.) If you successfully interrupted the boot sequence, you will be prompted with a Startup Menu. Option number 3 will be the "Password Recovery Procedure". Select this option.
8.) The terminal will display, "Current password will be ignored!". Press enter to continue with the boot sequence.
9.) The default account "admin/" will be enabled and you can log into the switch using this account. From here, you can set new accounts without having lost the switch configuration.
10.) After you have configured new accounts and documented the passwords, reboot the switch and log in normally to confirm that passwords have been recovered successfully.
11.) You are done. Disconnect and store the serial cable in a safe place for future use. Be sure to document a login username and password somewhere safe for future reference.
Welcome back for issue number 2 of the small business support community newsletter. Over the coming months we're going to share exciting news on the hardware and support community side. For now, we'll highlight our new favorite docs, pertinent...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Cisco is excited to offer its San Jose customers a unique opportunity to join us at Cisco headquarters for a design thinking workshop. This exclusive gathering, of no more than 20 people, is designed for an immersive interactive one-day session bet...