cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10788
Views
0
Helpful
2
Replies

Unable to get to the web interface for SG200-18

thgalind
Cisco Employee
Cisco Employee

Hi,

I got a new switch and am trying to connect a UCS server to it.  I can ping the switch just fine but when I try to use IE8 or firefox, I can't get to the web interface to configure it.

Here's my setup:

Cisco UCS C210 M2

IP = 192.168.1.100

Subnet = 255.555.255.0

Default Gateway = 192.168.1.1

SG200-18 Switch

Default IP = 192.168.1.254  (it's not DHCP)

Pointers anyone??

Tom G

1 Accepted Solution

Accepted Solutions

riroe
Level 3
Level 3

You will have to set a static IP address on the PC that is connected to the switch. The IP address of the PC

has to be on the same subnet as the 192.168.1.254.  You might have to try something lower than IE8. It should

work with Firefox and IE7. There is also a browser called GreenBrowser that usually works well with out switches.

THANKS

Rick Roe

Cisco Small Business Support Center

View solution in original post

2 Replies 2

riroe
Level 3
Level 3

You will have to set a static IP address on the PC that is connected to the switch. The IP address of the PC

has to be on the same subnet as the 192.168.1.254.  You might have to try something lower than IE8. It should

work with Firefox and IE7. There is also a browser called GreenBrowser that usually works well with out switches.

THANKS

Rick Roe

Cisco Small Business Support Center

Thanks Rick!  I got it to work with Firefox.  I forgot to set proxy settings initially but all is good now. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X