cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
479
Views
0
Helpful
5
Replies

VLAN Routing

mjaworske
Level 1
Level 1

I have a Cisco SG500-52P switch (2 actually, stacked in Layer 3 mode). I have setup Voice VLAN ID2 for our Mitel phone system. I have all ports untagged on VLAN1 and Tagged on VLAN2.  Our IP Scheme on VLAN1 is 10.0.0.x and on VLAN2 is 172.16.16.x. I need to have both networks talk as we have a software app (Xarios) on our computers that needs to talk to our phones. I need help getting the route setup.

5 Replies 5

michael o'nan
Level 4
Level 4

Have you configured ip routing on the switch yet?

Here is a quick setup guide I found

http://www.firewall.cx/cisco-technical-knowledgebase/cisco-switches/885-cisco-switches-sg500-52p.html

Honestly I'm not sure, Are you referring to IPv4 Static Routes?

 

You have two SVI interfaces on this switch that need to talk to each other. To accomplish this you would need to enter

SG500 (config)# ip routing

This will enable Inter-VLAN Routing

 

Is there a way to do it via the web interface?

 

It may be under IP Configuration > IPv4 Interface > tick box IPv4 routing at top of page. Or just console to the switch and type the one command.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X