SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s allow the handling of higher data rates. SFP ports empower SFP switches to connect various Ethernet and fiber cables through the network. There are also various types of SFP modules to suit your network’s needs. This article provides a complete list of officially supported SFP Modules and customer tested SFP Modules.
IMG 1 – An RV160W router with an SFP port
Official Supported SFP Modules:
Gigabit SX Mini-GBIC SFP Transceiver
Gigabit Ethernet LX Mini-GBIC SFP Transceiver
Gigabit LH Mini-GBIC SFP Transceiver
1000BASE-BX10-U Upstream Bidirectional Single Fiber; with DOM
IMG 2 – A Customer Tested SFP module attached to a router.
IMG 3 – Customer Tested SFP Module attached to a router with fiber optic cables attached
These are just some of the supported SFP Modules that may work on the Cisco RV 160 and 260 Series routers. We would love to expand this list and see if there are any other SFP Modules that our customers use. Please comment down below if you see an SFP Module not on this link and you worked with it. We also welcome any discussions on the SFP modules above. What are your thoughts and experiences with SFP on Cisco Business Routers and Switches?
Hello I purchased the SG250 for a small classroom. I just need it to act as a simple switch when connected to my 4510. I disable Spanning tree and most of the setting, whenever I try to uplink to my 4510 the port errors out.
Hello,I have a simple working IPv6 configuration with stateless autoconfig on Dialer1 and it is working fine. My config is this:!
ipv6 dhcp pool BVI1_DHCP
I'm wondering if anyone knows if the Vodafone K5161 or HUAWEI Balong B711 4G dongles will work in either the RV130 or RV320 routers? There are some Vodafone/Huawei dongles listed in the support documents but not those particular models.Thanks
My RV340 from February 2019 has suddenly decided to only run 100mbit on the wan1 port. Happens no matter which of my internet connections from 2 diffrent providers I connect to wan1. Both connections can run 1gbit without any problem on wan2.For wan1 syst...
Hi,I am trying to assign Static ip for Any connect VPN client, Has anyone done this setup before. I can see this option on LAN/VLAN but not sure if i put MAC address for AnyConnect Client, it will assign the static IP from the AnyConnect VPN Po...