With no other changes to either call manager or the SPA device, if I enter one call manager's IP address as the proxy and set the spa to NOT use DNS SRV, everything works perfectly. If I enter a domain as proxy and tell the spa to USE...
Good Day Community
I have a couple of Cisco SG300 Switches, and I am having an issue with regards to the Layer 3 configuration and as well as the VLANS.
I log into the SG300 GUI via the default IP which is 192.168.1.254, once I have logged i...
Hi, I've spent lots of time searching and reading and I cannot find the solution.
I would like to bind all traffic strictly from VLAN ID 50 to WAN2 (which means that if WAN2 is down VLAN ID 50 has no internet connection, even if the WAN1 is up).
Hello. I'm using Cisco RV340 with 2 independent ISPs under load balancing.
I wanna monitor each of these ISP in case they go down. By tracerouting I've chosen 1 IP inside each of their networks to monitor.
But, during tests, I figured that t...