Voice and Conferencing - Small Business

Hi All, At my workplace we have the CISCO IP PHONE SPA514-G.Our network cable runs to the phone then back out into our computers.Question: Is there a way for a notification to pop up on your computer screen to tell you when it's ringing? I often wear...

Hello,We are deploying the 6851 phones to a pizza restaurant. The current design they are requesting would be 3 premium extensions with basic call center shared to 5 phones. Everything works perfectly on the setup but we are running into an issue whe...

Hi everyone, Wonder if someone could share some light and help me with this configuration here?Am i missing something simple? !crypto ikev2 proposal Prop-customer1encryption aes-cbc-256integrity sha256group 19!crypto ikev2 policy POL-Customer1proposa...

I am trying to figure out how to get 2 SPA525G phones to be able to IP Address call each other. Any thoughts

So i am trying to install a WebEx kit for my work and we are having issues running the table top mics from the desk through the conduit all the way to the back room.   Does anyone know if wireless mics work with the WebEx Room Kit Plus Precision 60?

Where can I download SPC for IP Phone 6800/8800 Series with Multiplatform Firmware?

I would like to know how to whitelist TO and FROM sites on SPA-1001I can't find any articles telling me this is possible.Thanks, Jim

HelloMy son [who is not available to help] setup my home VOIP perhaps 10 years ago.I use a Linksys/Sipura SPA-1001 which continues to work marvelously.My provider has been Flowroute,.com,  This has saved me about $30/month compared to an AT&T home li...

I would like to access my ATA for programming via my home network IP address 192.168.1.XX.I am just using PSTN and a single SIP system, so not too fancy.How can I best do this? Do I need to use Bridge mode ? I tried switching to bridge mode, but my d...

Hello guys, Im new to Cisco and working in an environment with a UC500, is there anyone in the community with a SOP for deploying the appliance and managing/troubleshooting the appliance through CLI? Kindly share

There is a bug in the SPA50x/SPA51x latest firmware version 7.6.2SR6/7.6.2f. For examplefnc=sd;ext=4161500000 ,0123456@$PROXY;nme=TestThe SPA with version 7.6.2SR6 dials the number 4161500000 then waits 2 seconds and then sends DTMF begin '0' RTP pac...

Hello, I am working with a Cisco SPA232D that has been factory reset and put into Bridge mode.I am trying to register it to a Digium (Switchvox) phone system. I have set the registration password for the extension set on the Digium and am putting in ...

I had one of my SPA122 ATAs working perfectly with my FreePBX installation using SIP TLS and SRTP. I had it turned off for a month or two and just tried connecting it again and it doesn't work (SSL verify error or equivalent). I think that I read som...

Have had a UC520 in the field at my office for 10+ years, running 12.4(11r)XW3.  ATT has been providing their SIP connection via fiber and a Cisco router to UC, with the UC hitting a remote SIP server, and things have been working great.  They wish t...

Hi all hopeing you can help i have a ICS7700 system that was given to us as a startup to our business (trying to keep cost down) when powering on it only loads server 2000 but we wanted to start from fresh as we have all the cds that come with the or...