cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1363
Views
0
Helpful
2
Replies

541N WAP will not connect to network using PoE

paulwhavel
Beginner
Beginner

Hi, I recently purchased a couple of these WAPs and also purchases some PoE injectors to connect them.  The PoE injectors supply them with power, but not networking.  I've tried multiple injectors and verified they are not defective.  Is there any type of setting that needs to be adjusted to make this work?  If I power them using traditional methods they work fine.  Here's a link to the PoE injectors that I'm using:

http://www.versatek.com/products/gigabit-power-over-ethernet-injector.htm

Thank you for any help.

2 REPLIES 2

Check if the equipment is IEEE 802.11af  Complaint and provides atleast 10W at 48VDC.

pmurray209
Beginner
Beginner

Set the port on the switch to 10/100 full duplex.

I had the same issue with some 3com POE injectors and a 3com 2952 switch.

Left on auto the AP541 would get a poe link but no lan link.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: