01-10-2011 10:48 AM
I have 2 AP541n's on firmware 1.9.2.
They provide two SSID's on different vlan's, so far so good.
However, on the wireless neighbourhood tab it only shows one of the SSID's as being in the cluster.
The other SSID does show, but only when not in cluster or both is selected.
I can access both SSID's fine, its just this management page that doesnt quite work.
I have removed and added them again, it seems that only the SSID first in the list wireless -> wireless network setup page shows as being in the cluster.
Have I missed something or is this a feature?
If it is a feature, can it be fixed?
Paul
01-11-2011 02:41 AM
Let's just see if I understand you correctly:
You have
2 AP541n, set up in clustering mode, with two VAPs defined (on both, as a result of the clustering)? And only one of the VAP SSIDs is detected as in clustering mode?
//Svein
01-11-2011 03:15 AM
Hi,
See responses below
2 AP541n, set up in clustering mode, Yes
with two VAPs defined (on both, as a result of the clustering)? Yes
And only one of the VAP SSIDs is detected as in clustering mode? Not quite. There are 3 radio buttons (in cluster, not in cluster and both). Selecting both shows all the SSID's. Selecting in cluster shows only VAP 0. Slecting not in cluster shows all the SSID's.
I have attached some images showing the issue as well as the VAP config page.
Thanks
01-11-2011 03:39 AM
Well, at least you're getting more info than I was able to. I set up a secondary VAP, and lo-and-behold it didn't show up at all in the cluster neighbourhood. Only the primary SSID does.
I'm not sure this is "a bug", unless you count "limitations in the 802.11 standard" a bug.
//Svein
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide