cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1048
Views
0
Helpful
1
Replies

brand new wap561 green light keep flashing

yvesf70
Level 1
Level 1

got a brand new wap561 for a customer and out of the box, the green light keep flashing after 1-2 minutes and will never stop.

checked (and changed) poe adapter (twice) network cables, power cable.

I tried to do a factory reset (holding the reset for +10 sec.) and still the same

any idea???

1 Reply 1

Sujoy Paria
Cisco Employee
Cisco Employee

Hi,

 

I think you are mentioning about the 'Power' LED, if the 'Power' LED is flashing with green color that means the AP is "Upgrading firmware or acquiring an IPv4 address.". 

In case the device is connected to any DHCP server then you can disconnect that link and verify the status. You can check the rechability to the default management IP of that AP 192.168.1.245.

You may refer the link...

https://www.cisco.com/c/dam/en/us/td/docs/wireless/access_point/csbap/wap5x1/quick_start/guide/WAP_551_561_QSG.pdf

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: