I had to set up security connected directly to laptop but when I connect the WAP4410N to the domain network I can not access it using http://192.168.1.245 . What can I do to access this box before I put in its final location, on top of the office. is there something that needs to be set for it to communicate inside the domain network?
How are you trying to access the WAP4410 (i.e wireless or wired to a switch or router)? Please verify that you have set a static IP address (192.168.1.245) on your AP and that it is in the same Subnet as your network.If you are trying to access it wirelessly you have enable WLAN management. What is the error message that you are getting? Can you ping the AP?
did a web-ex with cisco and when he check it out everything was set up properly. it works now and I am setting up security.not sure what happend but when I contacted you I wasn't able to access it over the domain. thanks for the suggestions.
QuestionDear All,I'm currently looking for firmware version 188.8.131.52 for Linksys SPA400 Analog Telephony Gateway. Unfortunately, my device was bricked and I was able to recover it using a recovery tool and recovery firmware version 184.108.40.206 but can't find v...
Change in ASD Automatic Software Download Feature
Dec 13th, 2019
Cisco RV160, 260, 340, and 345 Series Routers
Due to an API change in Cisco’s software download platform the Automatic Download Feature (ASD) on RV series routers will be temporarily ...
SFP Module Support List for RV160x and RV260x Devices
Small form-factor pluggable (SFP) ports are included on the RV160 and 260 routers to allow the use of optical SFP transceiver modules. SFP’s convert the optical signals to electrical signals. SFP’s al...
Welcome and thanks for visiting the Small Business Community Newsletter. This is our first of what we will make a monthly newsletter where you will be provided information on New products and trends, What’s ...