02-26-2022 09:19 AM
For the life of me, I cannot figure this out so request some help.
I would like wireless users associating to SSID-A on my CBW140AC to be connected to VLAN50 and be sent out to internet via interface outside just like every other LAN connected clients on VLAN50. VLAN50 has a network of 192.168.50.0/24 with DHCP scope 192.168.50.4-192.168.50.32. Every wired clients work fine.
Similarily, wireless users associating to SSDI-B on the same CBW140C should be connected to VLAN90 and be sent out to internet via interface outside just like every other LAN connected clients on VLAN90. VLAN90 has a network of 192.168.90.0/24 with DHCP scope 192.168.90.4-192.168.90.32. The difference between the two VLANs is that VLAN50 is for untrusted devices (no inter device traffic allowed) while VLAN90 is for trusted devices (inter-device traffic allowed).
Cabled clients are already getting correct VLAN assignment and DHCP addresses so that works.
I have created the two SSIDs on the CBW140 and declared the association to the respective VLAN as defined above. The CBS250-16P switch port on which the WAP connects has native VLAN1 Untagged and both VLAN50 and VLAN90 as tagged.
The CBW140 is getting stuck in the red LED flashing after boot cycle. What am I missing?
What am I missing?
Solved! Go to Solution.
02-26-2022 11:57 PM
M.
02-26-2022 11:57 PM
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide