03-19-2020 11:42 AM
Hello,
i bought a 2x WAP371's for indoor and 2 571E's for outdoor to upgrade my house's wifi (was using providers modem-wifi) i hoped that my devices would have an easier time roaming around with 802.11R..
weirdly enough all my 3 devices connect on 5ghz and are still stuck on wifi A , so max sync 54mbps , and only if they are connected with the 371.. if they are connected to the 571E's they do go to AC 866mhz sync
the RSSI is -55 so im pretty close to them , i checked with 2 laptops, both have the intel 7260AC chip and are set to prefer 5ghz.
all accespoints have latest firmwares ( 1.3.0.7 for the 371's)...
the security code is set to WPA2-AES only (TKIP disabled)
i cannot find what im doing wrong with tthe 371's...
04-12-2020 04:52 AM
Hello @koolsbart41685,
My name is Anton and I am part of the Cisco SMB Support.
By saying "roaming around" do you mean that you have set up same SSID on all WAP's?
If so I assume you will need to configure WAP devices in cluster or in WDS mode as described in the links below:
Also is recommendable if you set same SSID for both 5 and 2.4 bands to enable band steer.
Kind Regards!
04-20-2020 07:17 PM
10-04-2020 06:12 AM
in the QoS , see if WMM if checked on or off
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: