Consumer Grade Device Needed to Bridge with 541N Access Point

[Ed Melendez]

I would like to know if it is possible to create an ethernet bridge with a Cisco 541N access point and a Linksys E-Series router such as the E1000 or the E2000...?  I currently have a 541N being used in my SOHO (Small Office / Home Office), and need to provide network access to wired devices in another area of the house.  I would prefer not to purchase another 541N for this would be overkill, and a second E-Series router may be needed for another area of the house.  If anyone knows of any other consumer grade products that would work, I'd greatly appreciate any suggestions.

Thanks In Advance,

-Ed

[Ed Melendez]

Anyone have any ideas about this?

Thanks,

-Ed

[streaves]

Hi Ed -- Thanks for participating in the Small Business Support Community. I recommend you post your question in the Linksys Forum where you'll get more response on consumer devices. Try this link: http://homecommunity.cisco.com/community/?category.id=linksys.

Thanks and good luck,

Stephanie Reaves

Cisco Small Business