cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

326
Views
0
Helpful
0
Replies
ronald.wickham
Beginner

How to manage a 240AC from multiple WLAN/SSID and VLAN - With RV260P

I just installed a RV260P Router with a 240AC AP in mesh mode with 141 Mesh extender.

 

I have setup the router with 4 VLANs (#1 left as default).I have set up the AP with 4 WLAN/SSID each mapped to a VLAN. I have left the port on the router for the AP as untagged on VLAN1 and then native VLAN on AP (Primary AP) set to 1.

 

From either a wired port or the SSID on VLAN1 I can reach the AP setup page, but I cant reach from the other VLANs. (VLAN's are set up for inter-VLAN routing) I can reach other devices. but not the AP setup page.

 

Any thoughts on what I need to change to allow me to access the AP setup page from other (multiple) WLAN/SSID or VLAN port?

 

Thanks in advance,

Ron

0 REPLIES 0