cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
592
Views
0
Helpful
6
Replies

Need help to setup a 1602i Cisco aironet

ahmed-2015
Beginner
Beginner

I recently got an 1602i-K9 access point and I can not enter a configuration part :

 * I do not have the static address management so I cann't use web browser 
 * When I plug my 1602 AP on a dhcp server, the bvi interface takes an IP address,  I cann't enter telnet and I cann't ping this IP adress
 * and when I use the console mode,I can acces the devise, get the enable mode but the command configure terminal does not work

Any help regarding the configuration of this device please ??

6 Replies 6

ahmed-2015
Beginner
Beginner

Hi,

Always in the same subject, 

Show version result : Version 15.2(4)JA1  

Commande Configure terminal doesn't work, may I upgrade device ? 

Thank you

Moin Ilyas
Enthusiast
Enthusiast

Could you please let us know if you would use it as Controller Based or Standalone Mode?

I am trying to use 1602i as standalone.

If you have it on Lightweight Image, follow the instructions to convert it to Standalone mode:

Lightweight to Autonomous Conversion

Once done, please refer to the following guide:

Cisco IOS Configuration Guide for Autonomous Aironet Access Points

I don't have a controller. The AP i Have is CAP not a SAP

Yes, you have Controller- based Image on it (CAP).

You'd have to change it to Standalone Image.

Please refer to the links, I've shared earlier.

Hope that helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: