cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

1024
Views
0
Helpful
1
Replies
EDDY MULDER
Beginner

Restric Access to Captive Portal after successfull authentication

I have setup a WAP321 with the captive portal activated.

2 WLAN networks defined, one for the Normal-user and 1 Guest-user access (with captive portal).

The WAP Management is on its own vlan (vlan 1 ) , network 10.0.0.0 /24

The Normal network has a different vlan (vlan 14) , network 192.168.14.0/24

Guest user(s) are on VLAN143 , 172.16.10.0 /24

So when a guest connects to the wap, the management interface is openend (10.0.0.x), after successfull authentication the user is redirected to a predefined site.

What i would like to establish is to make it impossible for the Guest-user(s) to access the management portal.

Defining an acl on the management portal is not possible as i would like to use any ip adres on the Normal Network (192.168.14.0/24).

unfortunally you can only define 5 Fixed ipaddresses and not a (sub)-network.

regards

eddy

1 REPLY 1
jurodri3
Beginner

Good morning  Mr. Mulder,

It it possible to set and access-list on your WAP321 that restrict access from users on the complete network 172.16.10.0/24.

Let me share with you the information found on guide me section on this forum about this topic.

I encourage you to make use of this useful tool if you have any other question about configuration on the future.

http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=c1a32843a14846af8c20a91532c39d16_acl.xml&pid=4&fcid=&fpid=&slnid=6

Check the section 6, where you could set the configuration using the network 172.16.10.0/24 as source address and 10.0.0.0 /24 as destination.

hope you find this answer useful, if it was satisfactory for you, please mark the question as Answered.

Thank you

Diego Rodriguez.

Cisco network engineer