cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
145
Views
0
Helpful
0
Replies

WAP 150 not available after firmware upgrade

I made a firmeware upgrade of my WAP150 from 1.1.0.9 to 1.1.1.0. The webiterface  showed the succesful upgrade and was rebooting the device. After that, the green led was blinking for hours and AP was not available on the network. After power off and power on, the green led was blinking.

 

Mr Len Lewin (Post from 2019-10-16) has also this problem. I think WAP150 has the old firmware as backup firmware and can activate it, if a firmware upgrade fails.

 

I tried to open a case, But with no luck, because support was only to 2017. Small business components have only a one year 
support at cisco? Is there any chance to get this device working again?

 

Best regards,

Bernhard Grotz