cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Please be advised, the GuideMe Wizard is no longer available on the Small Business Support Community. For search capability please use the community search field to find content related to Cisco Small Business documents, videos, and discussions.
156
Views
0
Helpful
3
Replies
Beginner

WAP321 Corrupt Image

Hi,

as described in the german quick guide, only the ethernet led is flashing quickly, seems like a bad image. Also checked with a sniffer, no traffic on the ethernet port. Thanks a lot! 

PID VID: WAP321-E-K9 V01

 

https://www.cisco.com/c/dam/en/us/td/docs/wireless/access_point/csbap/wap121/quick_start/guide/WAP_121_321_QSG.pdf

https://www.cisco.com/c/dam/en/us/td/docs/wireless/access_point/csbap/wap121/quick_start/translated_pdf/WAP_121_321_QSG_de_DE.pdf

 

3 REPLIES 3
Highlighted
Cisco Employee

Re: WAP321 Corrupt Image

Hi,

Flashing Ethernet / LAN LED indicates transmitting / receiving data on that interface. And after a new firmware installation if the power light is flashing quickly that indicates bad image.

What is the firmware version you are using on the mentioned WAP321-E-K9 V01 model?

Beginner

Re: WAP321 Corrupt Image

Hi,

the currently installed firmware is 1.0.6.5 i guess. Only the ethernet led is flashing, the power(using ac) and wifi led are both dead. cheers!

 

 

Cisco Employee

Re: WAP321 Corrupt Image

Hi,

Are you able to access the GUI of the mentioned WAP321 ?

For further troubleshooting you may contact us and open a service request with us following the below mentioned link…

https://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html