08-14-2019 12:27 AM
Hi,
as described in the german quick guide, only the ethernet led is flashing quickly, seems like a bad image. Also checked with a sniffer, no traffic on the ethernet port. Thanks a lot!
PID VID: WAP321-E-K9 V01
08-14-2019 07:11 AM
Hi,
Flashing Ethernet / LAN LED indicates transmitting / receiving data on that interface. And after a new firmware installation if the power light is flashing quickly that indicates bad image.
What is the firmware version you are using on the mentioned WAP321-E-K9 V01 model?
08-14-2019 07:40 AM
Hi,
the currently installed firmware is 1.0.6.5 i guess. Only the ethernet led is flashing, the power(using ac) and wifi led are both dead. cheers!
08-21-2019 06:47 AM
Hi,
Are you able to access the GUI of the mentioned WAP321 ?
For further troubleshooting you may contact us and open a service request with us following the below mentioned link…
https://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html
09-24-2019 01:40 AM
>Are you able to access the GUI of the mentioned WAP321 ?
Nope. It's completely dead.
>For further troubleshooting you may contact us and open a service request with us following the below mentioned link…
The AP has no service contract, so should i throw it away?
09-25-2019 03:47 AM
Hi,
Sorry for the inconvenience you are facing. As mentioned before, please open a service request with us following the below mentioned link…
https://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html
We will check for the possibilities to assist you in this case.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide