Hello,
My network is configured this way:
Router -> Cisco Access Point WAP4410N (default AP mode) -> 1st repeater -> 2nd repeater
I can connect through router (used as DHCP) and Cisco AP. It seems that from Cisco AP signal is not passed further the right way. The problem occurs when connecting via 1st or 2nd repeater. Connectivity is limited with no internet access. If I use static IP (for example 192.168.1.11) everything works.
Settings of Cisco AP:
IP: 192.168.1.245
Gateway: 192.168.1.1
DNS: 192.168.1.1
Repeater 1:
IP: 192.168.1.24
Gateway: 192.168.1.1
DNS: 192.168.1.1
Repeater 2:
IP: 192.168.1.25
Gateway: 192.168.1.1
DNS: 192.168.1.1