08-18-2009 04:10 PM
Greetings of the day:
Hello, I have a client who has three WAP4410N Firmware V 1.0.12 and Hardware Rev.12 all connected to an RVS4000 as a gateway, when using wireless clients to access wirelessly the management interface of all three only two open, the third one gets a page load error, when he closes one of the interfaces that did open and tries to open the one that didn't it works and the one that worked...does not for example .5 .6 .7 if .5 opens and .6 works .7 does not, if he shuts off .5 and tries to access .7 it works but .5 will not open. He is able to ping the device that won't open and able to go out to the internet, just no interface, anyone know if the wireless interface access is only two at a time? could this be a bug? he says the WAP4400N does allow more than two open at a time. Thanks in advance.
Regards,
Juan
08-18-2009 04:28 PM
Juan,
I've posed this situation to the WAP4410N product manager just now. He stated he will look into it and let me know what he finds out. I'll post his response as soon as I get it back from him. He did state this sounds like unusual behavior, but would need to verify that. I'll keep you posted!
Regards,
Glenn
08-19-2009 09:38 AM
08-18-2009 04:53 PM
[The reply was recalled.]
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide