02-13-2019 01:59 AM
Hello.
We have this issue on several computers and handheld devices, not all!
Issue:
When connecting to a SSID with a tagged VLAN “200”, devices receive IP addresses from DHCP in the default VLAN “1”, not the DHCP scope assigned to VLAN “200”. When setting static IP address, all is good – so device is placed onto the correct VLAN “200”.
I am aware of that VAN needs to be configured on every AP, like this community article describes: “WAP571 VLAN issue”.
I have a feeling it is the captive portal messing this up, but CP is disabled on every AP.
Br
Eirik
02-19-2019 06:10 AM
Hello Eirik,
The port on the switch should in trunk mode and should contain both VLANs - 1 and 200.
Check it.
Hope it helps
Cheers,
Mike
02-19-2019 06:16 AM
Hello
Thanks for your response. The switch ports are trunked.
I read that the WAP571 should be able to handle 32 VLAN's to SSID. I only seem to get one, in addition to the default VLAN 1.
I can reconfigure my first VLAN number and it allways works as expected. The second VLAN I add does not..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: