04-22-2019 11:39 AM
Hey everyone,
Just a quick technical question involving the Collector. So a customer of mine ran a Discovery job and the Discovery had populated the same router twice in the Live Nodes tab. Same IP, same everything. My question is twofold in regards to their concern:
Assistance to the question would be appreciated. Thank you!
Solved! Go to Solution.
04-22-2019 05:31 PM
Hello,
My first guess would be that the Duplicate Serial Numbers check was not set in the Discovery Settings. Next I would ensure that your customer's collector runs a collection before an upload. That should ensure that all duplicate data is overwritten before being uploaded to the portal. In the event that you see duplicate devices on the portal please send me a private message with your customer's Company and Inventory names as well as a list of affected devices and I will reach out to one of our L3s on your behalf.
I hope that helps!
04-22-2019 05:31 PM
Hello,
My first guess would be that the Duplicate Serial Numbers check was not set in the Discovery Settings. Next I would ensure that your customer's collector runs a collection before an upload. That should ensure that all duplicate data is overwritten before being uploaded to the portal. In the event that you see duplicate devices on the portal please send me a private message with your customer's Company and Inventory names as well as a list of affected devices and I will reach out to one of our L3s on your behalf.
I hope that helps!
04-23-2019 01:45 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: