cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Smart Net Total Care Community!

Our community includes Cisco experts to answer your questions about the Smart Net Total Care (SNTC) portal and CSP-Collector.
Click the navigation links below to access materials for using our service and supported collectors.

113
Views
0
Helpful
4
Replies
Beginner

UCS Fabric Interconnect 6248 is sending old data to CSPC

I decommissioned 24 B200 M2 blades.  In their place I installed 24 B200 M4 blades.  This was completed on Tuesday.  On Wednesday, we added the Fabric Interconnects IP address to CSPC and did a collection.  This was newly added and did not previously exist in CSPC.  The collection ran successfully and added the old blades instead of the new blades.

How exactly does the CSPC pull data from FIs when they are added via IP address?  Is old inventory data cached somewhere on the FIs?

4 REPLIES 4
Highlighted
Cisco Employee

Hello,

Hello,

Would you be able to show us some screenshots of the issue you're seeing?  You can view the raw collected data on the CSPC by going to Reports -> Collection Profile Run Summary and viewing the FI device to see what it may be sending.

Are you seeing the old data on the CSPC or the SNTC Portal?  It's possible that a new Upload has not been completed yet to the SNTC to show the updated device information.

Thank you,

Jarrett

Beginner

I'm seeing old data in the

I'm seeing old data in the SNTC.  This is on a brand new collection that was never done on the CSPC before.  Just to check, we purged all data from the CSPC and saw that it was removed from the SNTC.  We then re-added the IP address of the UCS Fabric Interconnect.  Once again, it pulled Serial Numbers, Product IDs, and such of 24 old blades that have not been in the environment in several weeks.  In some cases these are showing as N20-B6625-1 and some are showing as UCSB-B200-M3.  Many of these should be showing the UCSB-B200-M4 that have been installed for a few weeks.

Cisco Employee

Hi Jeremy,

Hi Jeremy,

In looking at the portal, it looks like the most recently pushed upload (05/07/2016) is still processing, so the data that is reflected in the portal is from 05/06/2016. This could explain why you are still seeing old data.

That being said, 4 days is longer than expected for processing, but could be because your upload was pushed during the scheduled down time this past weekend.

If you are still not seeing the expected data in 24 hours, please re-post and I will investigate further with the back-end team.

Thanks, Nathalie

Beginner

Nathalie,

Nathalie,

I am still seeing the incorrect data in the SNTC.

Thank you,

Jeremy

CreatePlease to create content
Right-rail
Navigation
Be sure to bookmark these support pages and use them in the future to find all the self-help information.
Helpful Links