cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
788
Views
0
Helpful
1
Replies

9200 & VNs

i_mohamed
Level 1
Level 1

C9200 supports only 4 VNs as documented in the datasheet. Is this limitation applies to the whole SDA Fabric? I mean: If i am using only 9200 in my network, but i have different sites (all under one DNA Center): will i be limited to only 4 VNs across ALL the network? or it is a local limitation per "each switch"?

In other words: can i create more than 4 VNs on DNA Center if i have only 9200 in my netwok?

1 Reply 1

jedolphi
Cisco Employee
Cisco Employee

Hello,

The fabric site that contains 9200 will be limited to 4 VNs. Other fabric sites will NOT be limited to 4 VNs if they do not have 9200. Also please note there is 9200 variants that supports only 1 VN and there is variants that supports 32 VNs. These are all documented in the 9200 data sheet and the SD-Access compatibility matrix, http://cs.co/sda-compatibility-matrix . As of right this moment I see the 32x VN C9200 SKUs are not listed in the SDA compatibility matrix, so please check with your pre-sales team about when they will be added.

Best regards, Jerome