Address Pool is not visible in Port Assignment DNA Center
I have couple address pools configured in DNA Center and correctly assigned to related VNs and all was good. Once when I tried to configure Multicast on particular network, DNA Center gave a "Provision Failed". After TAC case it was solved and now devices are provisioned correctly. The problem is, now, I dont see that particular pool in port assignments section. The devices, hold all information about that network and I can assign it manually from CLI but DNA center. I tried to re-sync devices but not result. Is there any way to fix this or I have to create another TAC?
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...
We are building out our first few AAR polices and are running into an error message.Built Global Policy with SLA class and traffic rules for voice traffic, attached to to the sites and VPN we needed, no issue. Building a second policy for management ...