Hi Guys, When im deploying a new switch via lan automation my new switch gets an orange light indicator on the primary seed but the secondary link gets a green light. After the deployment the primary link goes green. I can see the devcies in cdp neig...
Does the new 9300X platforms support co-located border/control plane function in SDA? This doc mentions it supports in control plane node scale table, but no mention in the table below it for border scale. https://www.cisco.com/c/en/us/products/colla...
I'm going to renew my DNA for C9300 switches, but I see that I can only renew DNA through March 2025. I have read that after expiration the switch will continue to function, but I would lose Network Advantage rights. My license shows as perpetual t...
HiIn DNAC we have an image marked as golden for all our 9300's is it ok to mark another image as golden so I can do a test software upgrade on one edge node ?, marking the other image as golden wont trigger an udate of all devices will it.?? Thanks
Hi, I have some questions related to FTD as fusion device. (1) Ciscolive 2022 Las Vagas BRKSEC-2845 (see attached) shows two possible topology.- Direct FTD attachementDNAC can only provision L3 handoff using /30, not /29 or /28. Hence, if i do this, ...
I tried to add catalyst 3560cx as an extended node to SDA fabric but I have this error message: Device tried to contact the server and failed during certificate_install how can I resolve this problem? is it possible to add extended node without using...
Hi,where can i find Visio Stencils, Shapes or Templates like the Graphics in the typical Cisco Live Presentations for the SDA-Family.it would be very practical to have the graphics from the presentations for DNAC, ISE, Border/Controlplane Node, Edge ...
HelloWe have an SD-Access infrastructure and L2-only vlan with PXE hosts. The FW is a DG for that VLAN and it connected thru L2 handoff.The problem is that PXE hosts can't boot for dozens of minutes after reloading the edge switch they are connected ...
Here is my question.... an example is if I have 5 states say California, Kentucky, Maryland, Utah and Florida. Can I manage them through DNAC from just one central site like Texas? Or do I need a separate ("3 DNACs)" equipment for each of the 5 ...
What's the correct way to do multi-tenancy in SD-Access? I haven't been able to find anything about it. Is it just using separate VN's? - but that doesn't seem like real multi-tenancy, as a single organisation/tenant could have multiple VNs for their...
Hi AllI m currently working on a solution to integrate an IP Phone ( SIP100) into the SDA network . I have successfully managed to authenticate and authorize the device via 802.1x through ISE but failing to obtain an IP address from the DHCP Server ...
Hi, I am reading this guide https://community.cisco.com/t5/networking-documents/how-to-cisco-dna-center-ise-integration/ta-p/3896410 on DNAC & ISE integration. (1) If i use self-signed in DNAC and ISE, just follow all the steps in the URL above and t...
Hi Guys, I spotted these errors in the DNAC and i was wondering is this a concern or is it normal? I can create and remove these as i would expect but the error indicates its associated to a VN and this must be removed before deletion. Can anyone exp...
Hi AllI m currently working on a solution to integrate an IP Phone ( SIP100) into the SDA network . I have successfully managed to authenticate and authorize the device via 802.1x through ISE but failing to obtain an IP address from the DHCP Server ....
I just updated AAA Server settings in the Network Settings for a site. How do I push that change to the devices assigned to that site? Nothing happens when I click save and device controllability is enabled. It says I either need to assign to a site ...
