Software-Defined Access (SD-Access)

Dear all,I have a reoccurring issue, where commands I manually remove from SDA devices keep showing up.I want to disable "snmp-trap enable traps syslog" on the devices. The first time I tried to do this via applying a template through network profile...

Hi All,Quick question hopefully. I noticed that when DNA Center provisions a L2 network within a fabric site, its allocates a L2VNID starting 8188 for local segments and 16196 for multisite remote border/anchor VN segments.If I remove and re-add an p...

Hi Everyone, I'm currently in middle of a rollout of Cisco SDA across our estate incorporating Cisco DNA Center, ISE, ACI etc. Its going well :). Most of my sites are either private fiber or leased circuits which have been migrated to Cisco without a...

Hi , Thank you so much . Does anyone have any idea how to onboard the stackwise virtual into fabric , as of today LAN automation is not supported.Im thinking of below approach , really appreciate your valuable suggestions.   1> Manually configure the...

Hi All,I operate a small number of SDA fabrics that all use the Deny-List (default Allow) Group-Based Access Control/TrustSec Model. I am not considering changing these to use the Allow-List (default Deny) model, however I'm aware that if the Default...

Hey all, I'm trying to provision a fabric device as a border node, and I get the following error: Failed to add device SW400-1.adamlab.local to the Fabric Site/Zone since 'ip routing' is not configured on the device. Please configure ip routing on th...

Hi All,I'm currently deploying a multi-site SDA fabric and I wanted to find out how others are managing the VLAN IDs that are assigned to IP address pools.When testing, DNA Center auto allocates VLAN IDs to IP Pools starting from VLAN 1021, however t...

Hi!We have built a SDA network but discovered that the access switches no longer send switch/port to the DHCP-servers.In our old network we used "ip dhcp snooping information option format remote-id hostname" on the access switches to be able to inse...

HII see in our DNAc that in Inventory we can add FMC devices now,  Can anyone tell me if I can still add them when the FMC is not part of the SD Access, and if so when added what am I able to do to the FMC once added , also is it no disruptive adding...

HiIs it possible to hand off the same L2 VN on multiple borders ?  I know it's not recommended to use the Border/CP for this function but I'm just exploring possibilities here.  So, for example, I have 2 Borders (either L2 only or Border/CP nodes).  ...

Hi,What is the point of redistributing BGP routes into LISP in SD Access?

HiAre there any special considerations needed for SD Access multicast when you’ve deployed an extranet policy.  I’m doing some testing and previously got intra-VN multicast routing working fine.  Now I have deployed an extranet policy to use the Infr...