10-08-2020 07:42 PM
Hi
I have a basic question.
After deploying an sd access campus network using dnac , should I always use dnac to make configuration changes or can I make changes directly on the cli ?
And if I do what is the possible impact
On the fabric setup ?
Thanks
10-08-2020 08:42 PM
10-12-2020 12:14 AM
If i still make changes on any device using the cli, is the device state going to change to unmanaged ?
10-12-2020 12:37 PM
Not really... The device will continue to stay in a Managed state... If Syslogs or traps are enabled to DNAC, then the moment there is a config change, the device will initiate resync or admin can manually resync from the inventory page.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: