cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
325
Views
0
Helpful
3
Replies
Beginner

DNA Center Upgrade 1.1 to 1.2.10

I have a DNA Controller in my lab for a few months. It is currently running on 1.1. Is it somehow possible to directly upgrade to 1.2.10?

3 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: DNA Center Upgrade 1.1 to 1.2.10

You need to go through cloud updates in series. You cannot jump to 1.2.10 directly through upgrade.

If this is the lab setup, you can do fresh install with iso image. There was some new requirement for mandatory requirement for cluster virtual ip introduced in 1.2.x . That should also be taken care.

 

 

 

View solution in original post

Beginner

Re: DNA Center Upgrade 1.1 to 1.2.10

Thanks, I thought so. The ISO is only available thorugh TAC? Or did I miss the download on your software page?

View solution in original post

Cisco Employee

Re: DNA Center Upgrade 1.1 to 1.2.10

Hello. Must open a TAC case to gain access to DNA Centre ISO. Jerome

View solution in original post

3 REPLIES 3
Cisco Employee

Re: DNA Center Upgrade 1.1 to 1.2.10

You need to go through cloud updates in series. You cannot jump to 1.2.10 directly through upgrade.

If this is the lab setup, you can do fresh install with iso image. There was some new requirement for mandatory requirement for cluster virtual ip introduced in 1.2.x . That should also be taken care.

 

 

 

View solution in original post

Beginner

Re: DNA Center Upgrade 1.1 to 1.2.10

Thanks, I thought so. The ISO is only available thorugh TAC? Or did I miss the download on your software page?

View solution in original post

Cisco Employee

Re: DNA Center Upgrade 1.1 to 1.2.10

Hello. Must open a TAC case to gain access to DNA Centre ISO. Jerome

View solution in original post

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards