DNA CENTER

[alhoula]

Hello, gentlemen

kindly I need your assist fo my case, which is:

I have 3 sites controlled by DNA Center and no IPAM for integration, so I have DHCP,

I got a task to create new VOIP pools to the sites using DNA Center, I did it but when I tried to assigne the new pool to a specific port the new pool doesn't show up from drop down menu! but the old one does!!

I found this configuration on the fabric edge switch for the old pool:

interface Vlan1039
description Configured from Cisco DNA-Center
mac-address 0000.0c9f.f46e
vrf forwarding EMPLOYEES_VN
ip address 172.25    255.255
ip helper-address 172.24.
ip helper-address 172.24.
no ip redirects
ip route-cache same-interface
no lisp mobility liveness test
lisp mobility 172_25_53_0-EMPLOYEES_VN-IPV4

how can I do the same (vlan creation, IP helper, GW) for the new pool?

I am struggling of where this configuration has been done? via CLI manually ? or It related to ISE? or via DNA? 

thanks in advance 

[mnagired · Accepted solution]

Hi,

Have you associated or add the new pool to the Virtual Network in host onboarding section?

[alhoula]

I created the pool only on the global site... could you please send me helpful steps to add it to the virtual network in host onboarding section? 

[mnagired · Accepted solution]

Can you refer to the below Segmentation guide and look for Process 8 --> Procedure 2 for detailed steps..

https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/cisco-sda-macro-segmentation-deploy-guide.html#Process8ConfiguringHostOnboardingwithPROVISIONApplication

[alhoula]

huge Thanks for your feedback, will do it and update here if it works.

[alhoula]

Thanks Dear it works