cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
725
Views
5
Helpful
2
Replies

Effect of switch removal from the Fabric

What would be the effect of removing a switch from the fabric in DNAC ? will it perform normally if we discovered it and added it to the fabric again ?  What is the correct procedure to remove the switch from the fabric ? in my case I released all ports assignment -> removed the switch from fabric -> removed it from provisioning page then it disappeared from inventory .

The question is do we need to do any thing before we rediscover the switch and add it again to the fabric?

 

Thanks in advance

 

1 ACCEPTED SOLUTION

Accepted Solutions
ldanny
Cisco Employee

Hi Hassan,

The steps you have taken would be the correct procedure.

There is nothing else that needs to be done but just to run a discovery to get started.

 

View solution in original post

2 REPLIES 2
ldanny
Cisco Employee

Hi Hassan,

The steps you have taken would be the correct procedure.

There is nothing else that needs to be done but just to run a discovery to get started.

 

tlim2
Cisco Employee