Hi,
I need to extend a temporary switch inside our network. There is no need for SGTs/Segmentation and my only requirement is to extend a VLAN on a new switch and have hosts plug into the new switch.
From my understanding, this should just be a matter of DNAC configuring a port-channel on an edge switch then configure the VLANs on the other end. Just like to check if this will be the right approach?
Regards,
Jayson
Hi Jayson
yes it is possible. In DNAC you configure your connected device type as trunk. create the vlans on the extended switch. Then configure your ports for the hosts to connect.
