07-14-2021 06:09 AM
Hello all.
Would be possible to establish more than one BGP session between the border node and two different fusion routers for the default gateway of fabric's traffic? I mean, during the IP transit configuration and L3 handoff process (which is automatized), is it possible to configure more than one BGP peering?
Thank you!
07-14-2021 08:23 AM - edited 07-14-2021 08:55 AM
In your fabric topology you can select the border node and when you go to specify its role, it brings you to the settings of the border node. This is where you define the border is an external border or internal or both, its local AS number, handoff IP Pool, the external interfaces to use and VN's. The automation will use the border handoff IP Pool and will take a /30 from this pool and configure a peering session per VN, per interface. You can define multiple external interfaces and assuming you are connected to fusions on separate interfaces, the interface config and bgp peering will be automated. With the /30's that are auto configured, you can then configure the fusion router's side with the corresponding IP from the same /30.
07-14-2021 09:10 AM
acc,
Yes, this is possible. You can even hand off some VNs to one peer device and other VNs to a different peer device if you wish.
With DNAC / SDA 2.2.2.3 and newer, you can now customize the VLANs used for the handoffs, and you can use the same VLANs across all borders in all sites if you want. See Table 8 at https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-2-2/release_notes/b_cisco_dna_center_rn_2_2_2.html#concept_ogz_jz5_rgb .
Cheers,
Scott Hodgdon
Senior Technical Marketing Engineer
Enterprise Networking and Cloud Group
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: