cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2112
Views
0
Helpful
2
Replies
krandrew
Cisco Employee

SDA L2 Hand-off on border node

Hi All,

 

Is it possible to configure a L2 hand-off on a border node that is already configured with both IP-Transit and SD-Access Transit?

 

Also, are there any restrictions using L2 hand-off on a Cat9600?

 

Many thanks in advance.

2 REPLIES 2
ldanny
Cisco Employee

I dont see a problem with this , as long as this is a dedicated interface which will be needed to be setup as a trunk for L2 handoff

Im not aware of any HW limitiations at this point.

mnagired
Cisco Employee

Hi,

 

No Restriction, but the recommendation is to use a separate device for L2 Border handoff to safeguard the entire Network meltdown due to Spanning tree issues.. Hope this helps..