At our DR site we have not purchased a Director Class switch for our environment. Instead, we have purchased two pairs(4) of MDS 9148s for our arrays, servers, data domain, etc.
The configuration would be two fabrics, 1 pair for VSAN 100 fabric A, the other pair for VSAN 200 fabric B.
I have DCNM installed and I can see the see pair, 1a, 1b as the fabric(s) defined.
1a, 1b have redundant paths for the VNX, Recover Point and Data domain ports. I would like the 2a/2b side to host the servers that I can zone to the storage array.
My question is can I make the first switch 1a, the principal, and the 2nd (2a) edge the subordinate by creating an ISL link between the two. I would like both switches in the same vsan(1a, 2a, vsan100), 1b,2b(vsan 200).
I have only done this using the core-edge topology so I wasn't sure if I an do this with edge-edge.
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution must...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...
Recommended for customers on ACI releases 4.2(7r) and above or 5.2(3g) and above. Are you tired of manually gathering ACI logs and tech-support data?To this day, the process of gathering ACI logs and uploading them to your TAC case was cumbersome - y...