hello,I have tried a few things, but im still at a loss. i cannont create a vsan database on my 7k switch. i go into config and try and it errors out. any ideas?thanks,Howard.
I would like to monitor the SFP health using SNMP, can you please help me find the right OID for this. I tried searching in Cisco SNMP Object navigator and found that OID 1.3.6.1.4.1.9.12.3.1.8.46 - 1.3.6.1.4.1.9.12.3.1.8.50 gives ...
I have multiple storages and VSAN's on the switch, I know 4 WWN's on a host, and believing they are zone with a storage, how do I locate the port of the storage and it's WWN, better using CLI? Thank you!
Device managerMake any chances to a port IE enable, label, etc.., click on Admin, Click on save configuration, Prompt-Really save running to startup configuration? Select yes, receive a message, snmpd: another copy operation in progress. Only one ope...
We have a qlogic HBA (qla2xxx) running on Red Hat that seems to be failing on OS startup. Exactly how its failing I am not sure. The card was connected to a Cisco UCS environment but was removed and is now connected to a cisco 9138 but fails at ...
Hi,I need some advice when it comes to how to setup a port-channel between Nexus 5548UP and a HP StoreVirtual 4330 device. The idea is to use 2 10 GB ports in a port-channel group and this far I've this on the port-channel group; interface port-chann...
I'm trying to pull fibre channel error statistic counters on a Nexus 5596 but it looks like the IF-MGMT mib is not implemented.If there any OIDs accessbale via SNMP to get the following values (Examples from show output in the CLI) via snmp?Input: di...
Hi All,I am pretty new on storage world and now I am working on lab for testing FCoE multihop. I have some questions that need to be clarified and some caonfiguration example that need to be corrected. I have also attached the logical topology for my...
Hello Teamkickstart: version 4.2(7d)system: version 4.2(7d)2011 Apr 14 18:03:43 jiph101f01 %RADIUS-3-RADIUS_ERROR_MESSAGE: All RADIUS servers failed to respond after retries.2011 Apr 14 18:03:45 jiph101f01 %AUTHPRIV-3-SYSTEM_MSG: pam_aaa:Authentic...
HiI have 2 cisco 5548UP in my test setup.I had earlier configured the sw for fcoe with an active zoneset with only the first 4 ports used as fcoe.I now plan to use the last 4 ports 1/32-1/28 as native fc.As a test I connected an 8gb cisco sfp tp port...
Dear All,we have Fabric Manager 5.07 installed on Windows Server 2008. Everything is working fine without this little problem:Every time I start FM I get this Error message:FM standalone was unable to bind to Syslog port as It was already in use, thi...
Hi All,I'm new to Cisco UCS and don't fully understand it's compatibility with non-Cisco gear. My questions are primarily driven around the concept that Cisco UCS smartplays appear to be significantly cheaper than the traditional configurations that ...
We are planning to decomission few of our unsupported storage arrays from environment.Hence we need to remove few zones from mds switch.I would like to ask that if i run no zone command e.g SW1(config)# no zone <zone names>would this be good to remov...
Just purchased a couple of 9216i for the lab. I am looking to upgrade to 4.x software. However, whenever I try to upgrade I get the following error. I can't got to this version. Looking it up, it appears to be an incompatible software image. Ac...
