MDS 9124 Lun Based Zoning Configuration

[Burak Atasal]

Hi all,

I'm trying to configure lun-based zoning on MDS 9124 Switch but i'm doing something wrong. If there is someone with experience about this any advice can be handle. I looked everywhere to find a configuration guide or example but didn't find anything about it.

thanks

[dakester]

Hi,

Can you post the commands and error error message?

Please be aware of this.

http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_2/release/notes/nx-os/mds_nxos_rn_526a.html#wp914453

(not supported on gen4 linecards)

Do you have gen4 linecards in the fabric?

You will also need an Enterprise License

http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/nx-os/configuration/guides/lic/lic_5_0_published/b_Cisco_MDS_9000_Family_NX-OS_Licensing_Guide_Release_5_0_1a_chapter_00.html#concept_85A008583B084BF5827A1CC9DD4357D9

Also, lun zoning is not available  in interop mode.

http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/fabric/nxos/zone.html#wp1136480

Last, after configuring a zone, place the zone in a zoneset and activate the zoneset.

Regards,

David

[Burak Atasal]

Hi David thank you for your reply.

First of all i'm using MDS 9124 with Enterprise License (grace period 118 days remains). I'm configuring zoning but when i try from server and scan the vHBAs to see LUNs. But server seing all LUNs attached.

I'll try couple of different things and post here tonight.

Burak