cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

356
Views
10
Helpful
3
Replies
Oystein Kaldhol
Beginner

Native FC ports on FEX C2348UPQ?

Hi

 

Im pretty fresh on Nexus, so please bear with me. We have two Nexus 5672UP, and just purchased two FEX C2348UPQ. AFAIK, the C2348UPQ have 48 unified ports, and currently support 2-4-8Gbps native FC, with hardware support for 16Gbps FC(but lacking software support as of yet).

My question is, how do I set the ports to FC mode?

On the 5672UP it was pretty straightforward, we just did a:

slot 1

port 33-48 type fc

 

So, how do I do the same for the FEX? It doesnt show up as a module when I do a "show module".

The fex is in this case is fex 131, so I tried a

slot 131

port 25-48 type fc

which yields

ERROR: Invalid slot specified

 

Any suggestions would be much appreciated.

 

 

2 ACCEPTED SOLUTIONS

Accepted Solutions
Paresh Gupta
Cisco Employee

Nexus 2348UPQ does not support FC as of now.

View solution in original post

Yes, entire FC functionality in one of future releases

View solution in original post

3 REPLIES 3
Paresh Gupta
Cisco Employee

Nexus 2348UPQ does not support FC as of now.

View solution in original post

So the entire FC functionality on that FEX is to be released in the future? I was under the impression that it was only the 16Gbps speed that wasnt supported yet. Well, thank you anyhow, that explains it all I guess.

Yes, entire FC functionality in one of future releases

View solution in original post

Content for Community-Ad
This widget could not be displayed.