I'm installing a pair of 1010v-X appliances using flexible network option 5 on version 4.2(1)SP1(5.1).
I have all interfaces grouped into a single port channel 6. All interfaces uplink to a pair of Catalyst 6506Es in a VSS (Sup2T).
My question relates to the VSS configuration.
For example, do I set up one port-channel on the VSS and put all 12 interfaces in it? Or, do I set up two port-channels on the VSS and put the active 1010v-X in one port-channel and the standby into another port-channel?
Do I set dot1q trunking up on the port-channel(s) on the VSS?
In the previous article, we have seen, how to assign IP Address to Cisco UCS Management Interface. This way we gain access to the on-board management software called Cisco Integrated Management Controller (CIMC).
The next step of building UCS Server ...
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...