cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1464
Views
5
Helpful
3
Replies
Highlighted
Beginner

Nexus 5548UP information

Hi,

Is there a way to show from the CLI whether the switch is a 5548P or 5548UP ?

I have seen the physical labeling but wanted to a way to verify via the CLI.

2 ACCEPTED SOLUTIONS

Accepted Solutions
Highlighted
Contributor

You can run the "show inventory" command and it should show you what you need. You can also try "show version" but I don't think it shows up in that output.

 

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/command/reference/fund/n5k-fund-cr/n5k-fund_cmds_show.html

View solution in original post

Highlighted
Contributor

You can also do the command "show module" that will give you almost the same output but easier to read.

View solution in original post

3 REPLIES 3
Highlighted
Contributor

You can run the "show inventory" command and it should show you what you need. You can also try "show version" but I don't think it shows up in that output.

 

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/command/reference/fund/n5k-fund-cr/n5k-fund_cmds_show.html

View solution in original post

Highlighted

Okay I see it now under PID...that was easy.

 

Thanks!

Highlighted
Contributor

You can also do the command "show module" that will give you almost the same output but easier to read.

View solution in original post

Content for Community-Ad