cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1813
Views
0
Helpful
1
Replies

SYSMGR-STANDBY-6-SERVICE_STARTED:

healyj4
Level 1
Level 1

Hi,

IHAC whose MDS streams the following, seen on 2 switches so far:

2011 Mar 18 06:06:59 mds %SYSMGR-STANDBY-6-SERVICE_STARTED: Service "System Manager (core-client)" in vdc 1 started with PID(26690).
2011 Mar 18 06:07:00 mds %SYSMGR-STANDBY-6-SUBPROC_SUCCESS_EXIT: "System Manager (core-client)" (PID 26690) has successfully exited with exit code SYSMGR_EXITCODE_SUCCESS (0).
2011 Mar 18 06:08:33 mds %SYSMGR-STANDBY-6-SERVICE_STARTED: Service "System Manager (core-server)" in vdc 1 started with PID(26709).
2011 Mar 18 06:08:33 mds %SYSMGR-STANDBY-6-SUBPROC_SUCCESS_EXIT: "System Manager (core-server)" (PID 26709) has successfully exited with exit code SYSMGR_EXITCODE_SUCCESS (0).
2011 Mar 18 06:10:00 mds %SYSMGR-STANDBY-6-SERVICE_STARTED: Service "System Manager (core-client)" in vdc 1 started with PID(26711).
2011 Mar 18 06:10:00 mds%SYSMGR-STANDBY-6-SUBPROC_SUCCESS_EXIT: "System Manager (core-client)" (PID 26711) has successfully exited with exit code SYSMGR_EXITCODE_SUCCESS (0).
2011 Mar 18 06:11:33 mds %SYSMGR-STANDBY-6-SERVICE_STARTED: Service "System Manager (core-server)" in vdc 1 started with PID(26728).
2011 Mar 18 06:11:33 mds %SYSMGR-STANDBY-6-SUBPROC_SUCCESS_EXIT: "System Manager (core-server)" (PID 26728) has successfully exited with exit code SYSMGR_EXITCODE_SUCCESS (0).
2011 Mar 18 06:13:00 mds %SYSMGR-STANDBY-6-SERVICE_STARTED: Service "System Manager (core-client)" in vdc 1 started with PID(26735).
2011 Mar 18 06:13:00 mds %SYSMGR-STANDBY-6-SUBPROC_SUCCESS_EXIT: "System Manager (core-client)" (PID 26735) has successfully exited with exit code SYSMGR_EXITCODE_SUCCESS (0).

Any ideas of the meaning/switch impact.

Thanks and rgds,

Jim.

1 Reply 1

kenk
Cisco Employee
Cisco Employee

Hello Healyj4,


The messages are informational (not indicative of a problem).


These messages are informational only and if you do not want to include
informational and debugging messages in the logfile,
then please configure:
  
     logging logfile messages 5  ( this is the default )

If the above does not resolve the issue, I would recommend opening a Service Request with the
appropriate TAC team.

Regards,

Ken

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: